User guide

Chapter 11: Command Line Interface
197
Command
Description
associate
Associate a Power Strip outlet to a SX Port.
association
View Currently configured associations.
cycle
Power cycle specified ID.
Note: If you are connecting a PX to the SX, it is
recommended you set the power cycle time to 5
seconds.
off
Power off specified ID.
on
Power on specified ID.
outlet
Edit outlet information.
powerdelay
Configure global Power Strip delays.
powergroup
Switch to Power Group Menu.
powerstatus
Get Power Strip status.
powerstrip
Edit Power Strip information.
setpowerport
Configure an SX Port to contain a power strip.
unassociate
Remove a power outlet association from an SX
Port.
unsetpowerport
Configure an SX Port to remove a power strip.
See CLI Command for Power Control (on page 235) for details about
power command scenarios.
Diagnostic Commands
The diagnostic commands allow you to gather information for
troubleshooting.
Command
Description
ifconfig
Show detailed network configuration
netstat
Print network connections
ping
Ping a remote system
ps
Report system process status
traceroute
Trace the network route to a host
[-dnrv] [-m maxttl] [-p port#] [-q nqueries] [-s
srcaddr] [-t tos] [-w wait] host [data size]
uptime
Print the current system uptime information