User guide

Chapter 11: Command Line Interface
206
Reboot Command
The reboot command restarts the SX console server. This command is
only available to users with administrative privileges. All user sessions
are terminated without warning, and no confirmation is required. It is
highly recommended that you ask all users to log off before you reboot
the unit. The userlist command can be used to display a list of connected
users and sessions.
Syntax
reboot
reboot Command Example
admin > Maintenance > reboot
The system responds with the following messages:
Rebooting the system will log off all users.
Do you want to proceed with the reboot? (no/yes)
(default: no) yes
Restore Command
The restore command retrieves a copy of the SX system from a system
and writes the file to the SX server.
Syntax
restore [ip ipaddress] [login login] [password
password] [path pathname] [file filename]
restore Command
Description
[ip ipaddress]
IP address of the target system from which
the restore data is retrieved
<login login>
Username of the account on the system
where the restore data is stored
<password
password>
Password for the above account
[path pathname]
Specifies the path to the backup file to be
restored to a similar system with the same
port density
[file filename]
Specifies the name of the file in which the
backup data was saved