Owner`s manual

Rascal R6 300 Scooter Owner’s Manual
EMC Part: 19277200 • Rev. 06 • 09/04/2007
12
Adjustments
Your scooter has been pre-adjusted to meet most customers’ needs, however your scooter includes
several adjustments to adapt it to specific height and width requirements. These adjustments include:
• Adjusting the Seat (armrest width and armrest/backrest angles)
• Adjusting the Handlebar and Dash Position
Instructions to perform these adjustments are presented in the following section:
Adjusting Armrest Width
The two armrests of the seat can be adjusted to different
widths. Armrest adjustments are shown in Illustration 4.
Illustration 4 — Armrest Adjustments
Follow these instructions to adjust armrest width:
• Loosen corresponding knob behind the seat
• Adjust width by pulling armrest out from seat to
desired position
• Re-tighten knob to secure armrest at selected
width
Be sure to repeat armrest adjustment on other side
before riding.
Adjusting Armrest Angle
In addition to width adjustments, the armrests of the
seat can be set at different angles for greater comfort.
Follow these instructions to adjust armrest angle.
• Lift armrest to full up position.
• Locate adjustment bolt within armrest joint. Turn
bolt to vary armrest angle (wrench may be
needed).
• Put armrest down into riding position and test for
comfort before riding.
LOOSEN
KNOBS
MOVE TO
ADJUST
19271200/4