Owner`s manual

Rascal R6 300 Scooter Owner’s Manual

EMC Part: 19277200 • Rev. 06 • 09/04/2007

Adjusting the Handlebar Assembly and Dash

Position

Both the handlebar assembly and dash include

adjustments to allow them to be positioned according to

your individual riding style. The angle of the dash can be

adjusted up or down for maximum comfort and easier

use of dash controls. The entire handlebar assembly can

also be adjusted through a movable handle at the base of

the lower handlebar assembly. Dash and handlebar

assembly adjustments are shown in Illustrations 7 and 8.

Adjust dash angles so that your elbows can rest on the

armpads while you operate your Rascal and you can see

the dash controls.

• Sit in seat facing forward.

• Lift dash to upright position to access adjustment

screw.

• Locate adjustment screw. Use allen key (supplied)

to turn screw clockwise to lower the angle or

counterclockwise to raise dash angle.

Illustration 7 — Dash Adjustment

Adjust handlebar assembly positions so that the

handgrips are within comfortable reach.

• Sit in seat facing forward.

•While holding the handlebar, reach down to the

base and loosen the locking adjustment handle by

turning handle counter-clockwise.

•When at desired angle, tighten locking handle by

turning clockwise.

Note: Lever can be positioned out of the way by pulling

lever out and moving it away from rider. Release lever

and it will lock in place.

Illustration 8 — Handlebar Assembly

Adjustment

19271200/7

ADJUSTMENT

SCREW

LOCATION