Owner`s manual

Rascal R6 300 Scooter Owner’s Manual

EMC Part: 19277200 • Rev. 06 • 09/04/2007

Vehicle Disassembly & Re-Assembly

Your vehicle has been designed for easy disassembly for convenient transporting and storage. The

sequence listed below is for complete disassembly of your vehicle. Assembly is accomplished by

reversing these steps. You may only need to disassemble a portion of the vehicle depending on your

space requirements.

Removing the Front Basket

1. Grasp Basket firmly.

2. Pull straight up and off the Mounting Post.

Removing the Dash

1. Remove the seat.

2. Stand the scooter on its bumper and follow the tiller harness to locate the connector.

3. Pull connector away from socket.

Re-Assembly Notes: Ensure that connector latches in place. Verify that the front wheel(s) and the

handlebar are pointed in same direction before reassembling.

Removing the Handlebar Assembly

1. Remove the seat.

2. Stand the scooter on its bumper and follow the handlebar assembly harness to locate the

connector.

3. Pull connector away from socket.

4 Remove handlebar assembly from mounting location. For convenience, handlebar assembly can be

“stowed” in opening directly opposite mounting location.

Re-Assembly Notes: Ensure that connector latches in place. Verify that the front wheel(s) and the

handlebar assembly are pointed in same direction before reassembling.

Removing the Seat

1. Hold the Locking Lever backward (located on side of seat).

2. Lift the seat straight up and off the Seat Post. Seat post has been factory-lubricated with

petroleum jelly for ease of movement. BE CAREFUL to keep lubricated areas free from clothing,

carpets, etc. to avoid stains when removing seat.

Removing Batteries

1. Remove top cover and unwrap the battery tie down strap.

2. Unplug the connectors attached to each battery and lift each battery up and out of the vehicle.

Re-Assembly Notes: Make sure that the Velcro straps are securely and completely fastened. It is

normal for the batteries to spark when re-assembled. This does not cause any damage to the batteries.