NEE Tle /ATTENTIONS & An adult should read and understand the content of this manual before use Assembly and use of the product should be conducted only under adult supervision. & To avoid injury. the use of knives and tools in the assembly of this product should be performed by an adult. & When not in use, store the product away from small children. » Plastic bags are cottons and nay cause a choking hazard Please dispose of them responsibly tater use.
TOOLS (NOT INCLUDED) Knife Tweezers Scissors Flat-gone pliers Components! Assembly of Components Use flat-nose pliers to clip the compo& Peel off the sticker with tweezers and flatten it on the bent off, and then use knife to tim the component. interface part io be smooth. AN WARNING: Tools must be used by adult (knife, tweezers, flat nose pliers, scissors), please be.
CAR BODY | STICKERS _# CAR BODY The engine, suspension and driver's cal of the car are all black, the car body is red and the wheels are painted in silver, The stickers will be displayed during the following assembly process, you can also refer to the package drawing. USE OF THE STICKERS FOR CAR BODY {1)Take the stickers cub {2)Carefully peel the sticker off with tweezers. {3)Hold the edge of the back plate-and put the sticker an the model. {4)Fix the sticker with fingers and make the sticker in place.
Le AAS [1] The item nimbler of the applicable remote controller is 91800. i21 There are numbers corresponding to each model, please do assembly based on the corresponding numbers according to instructions.
Stickers. jon the corresponding position according tithe seal number marked in the figures’, {1} Install Bunion B30. {2) Install B24-as shown in the figure.
Stickers on the corresponding position according to the serial number marked in the figures. {1) Install AB into 2 as shown in the transfigure D41 and D42 on Ag. {2) install C38 and C39 0n 1.
10 Insert theorist: bones on fhe bottom-of D40 into the platform of Ad, the bottom edge should be thousandth, and then press the pillars oh hitherto of DA0 inch A4, (1) Install B22 on AL. (2) Install B25 oh A4.
12 {1} Install AS into Ad:as shown in the figure. (2) Install B18 dnd BIS on the outside of 1 and as Bi2 shown in the figure. (3) install B12 dnd B13 respectively oh the left and right sides of 1.
14 Please put the stickers on the corresponding position according tithe serial number marked in the figures before assembly, (Th install A7 on.
Sticker son the corresponding position according 1o:the serial umber striated in the figures | (1): Install AB into C36. ge showy iy the figures. (2) Install B16 into B14, and parentheses the installed Bi4 into the hole of C36 as shown in the figure, (3) Install. AS into: C37 as shown in the figure. Ay Install B17 into B15, and then insert reinstalled BIS into the hole of C37 as shown in the figure.
16 insert the Upper bone of AB and.