User`s manual

Rastergraf

Introduction - 3

Notices

Information contained in this manual is disclosed in confidence and may

not be duplicated in full or in part by any person without prior approval of

Rastergraf. Its sole purpose is to provide the user with adequately detailed

documentation to effectively install and operate the equipment supplied.

The use of this document for any other purpose is specifically prohibited.

The information in this document is subject to change without notice. The

specifications of the Eclipse3 graphics boards and other components

described in this manual are subject to change without notice. Although it

regrets them, Rastergraf assumes no responsibility for any errors or

omissions that may occur in this manual. Customers are advised to verify

all information contained in this document.

The electronic equipment described herein generates, uses, and may

radiate radio frequency energy, which can cause radio interference.

Rastergraf assumes no liability for any damages caused by such

interference.

Rastergraf products are not authorized for any use as critical components

in flight safety or life support equipment without the written consent of the

president of Rastergraf, Inc.

These products have been designed to operate in user-provided PMC,

CPCI, and PCI-compatible computers. Connection of incompatible

hardware is likely to cause serious damage. Rastergraf assumes no liability

for any damages caused by such incompatibility.

Rastergraf assumes no responsibility for the use or reliability of software

or hardware that is not supplied by Rastergraf, or which has not been

installed in accordance with this manual.

The Eclipse3 graphics boards are manufactured and sold under license

from Curtiss-Wright Controls Embedded Computing (CWCEC). Contact

Rastergraf, Inc. for additional information.

Rastergraf is a trademark of Rastergraf, Inc.

All other trademarks and copyrights are the property of their respective

owners.