User`s manual
14
Copyright
©2003 RATOC Systems,Inc. All rights reserved. No part of this publication may be reproduced,
store in a retrieval system, or transmitted in any form or by any means(electronic, mechanical,
photocopying, recording or otherwise) without the prior written consent of RATOC Systems,Inc.
Trademarks
-Windows is a registered trademark of Microsoft Corporation.
-Other brand and product names may be registered trademarks or trademarks of
their respective holders.
Changes
The information in this User’s Manual is furnished for information only and is subject to change
without notice. RATOC Systems,Inc. reserves the right to make changes in the product design or
product improvements without reservations and without notification to its users. RATOC
Systems,Inc. assumes no responsibility or liability for any errors or inaccuracies that may appear in
this document.
Regulatory Agency Notice
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
(4) Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance may
result in this unit not complying with FCC Rules Part 15.