Instructions / Assembly

Step 3

Use only the hand pump provided to inflate

kayak. Inflate until the cover is tight and

product feels firm. Do not use an air

compressor to inflate your kayak. Use of a

compressor can quickly over-inflate and

rupture the kayak bladder.

Step 4

Zip on the backrest and clip both support straps to the rings located

on the outer edges of the kayak cover.

Step 5

Connect the three pieces of aluminum

together using the two couplers.

Tighten the collets on the ends of the

couplers until snug and the aluminum

shafts can’t be pulled out. To avoid

cracking the plastic pieces, do not over

tighten.

Orient the paddles to the desired position on the ends of the

aluminum shaft and tighten the collets until the paddles are snug

and cannot be slipped off.