User's Manual

4002 BATTERY REPLACEMENT
Requires (2) CR2032 3 volt batteries.
REMOVAL:
1. Remove the battery
compartment cover
located on the back of
the hand control
(FIGURE 1).
2. Press the round-
shaped tab (FIGURE 2)
and each battery will
eject from the plastic
captive clip (FIGURE 3).
3. Grasp and remove
batteries. Note
position of batteries
when removing for
replacement.
REPLACEMENT:
4. Position the new
batteries face-up
and insert into the
plastic captive clips
(reverse of removal).
5. Carefully push
batteries in and
down to install.
6. Replace battery
compartment cover.
FIGURE 1
PUSH IN (SLIGHTLY)
AND SLIDE OFF
BATTERY
COMPARTMENT
COVER
FIGURE 3
WHEN BATTERY EJECTS
FROM CAPTIVE CLIP,
ROTATE UP AND OUT
OF BATTERY
COMPARTMENT
TO REMOVE
4002 PROGRAMMING
To set channels on a single base:
1. Plug the bed into a power
source and within 30 seconds,
press the head up button on
the hand control until the
transmission indicator light
illuminates. This will confirm
that the hand control and the
bed are communicating.
2. The hand control channel is
now programmed.
To set channels for 2 or more
beds to operate independently:
1. Unplug all beds from their
power sources.
2. Plug in the first bed to be
programmed and within 30
seconds, press the head up
button on the hand control until
the transmission indicator light
illuminates. This will confirm
that the hand control and the
bed are communicating.
3. Repeat steps 1 and 2 with each
base requiring programming (It
is important to use the specific
hand control that will be used
to operate the bed). Beds prior
programmed with the remote
need not be unplugged.
4. Multiple beds are now
programmed for independent
operation.
Note: In the event of power
failure or if bed is inadvertently
unplugged from the electrical
power source, wait 30 seconds
(after power is restored) before
using any hand control. This
will prevent bases from
learning and working
simultaneously.
FIGURE 2
PUSH DOWN
ON TAB TO
EJECT BATTERIES
BATTERIES