Instruction manual

Step 5:

Fasten the Reflector

to the Antenna Back Bracket by using one 5/16" x 3/4" UNC Carriage

Bolts inserted through the top hole on the dish and place a 5/16" UNC Serrated Flange Nut on the bolt.

Carefully holding the reflector, locate the bolt and lower the reflector onto the antenna bracket by

sliding the bolt down through the fork if the top tab on the antenna bracket. Use the remaining 5/16” x

¾”UNC carriage bolts and through the four remaining tabs located on the Antenna Back Bracket. Secure

the Dish to the Antenna Back Bracket using a 5/16" UNC Serrated Flange Nut on each Carriage Bolt and

tighten with a ½” wrench to 20Nm (177lbf.in) (fig 5).

ure 5