Operator`s manual

Chapter 8
46 SmartBoom and SmartRow Installation and Operation Manual
Individual Fore/Aft Offset Screen
To get to the Sctn 1 F/A Offset screen, press from the last Sctn L/R Offset screen.
Note: These screens will only appear if “No” is selected on the AutoLocate Sctns screen.
The Sctn 1 F/A Offset screen displays the distance section number 1 is located in front of (fore) or
behind (aft) of the center of the GPS Antenna.
Press key to edit the L/R Sctn Offset. The number will begin blinking to indicate you are in edit
mode. Use the or key to increase or decrease the value representing the Fore/Aft offset of
the section. Use the key to move between digits and Fore/Aft selection. Press the key again
to finish editing.
Note: Continue pressing to wrap the curser back around to the most significant digit.
Press to edit the Individual F/A Offset for sections 2-10. The actual number of Sctn Fore/Aft Offset
screens will depend upon the number of sections programmed on the # Of sctn screen.
Sctn 1 Fore/Aft
50” Aft
RAVEN
HOME
INDUSTRIES