Operator`s manual

Manual No. 016-0171-093 59
SmartBoom/SmartRow Configuration Screens
Console Port Screen (SmartBoom Only)
To get to the Console Port screen, press from the Port D Baud Rate screen.
The Console Port screen allows you to change or disable the port that communicates with a Raven
console.
Press to change the Console Port setting. The setting will begin blinking to indicate you are in edit
mode. Use the or key to toggle between ports ‘A’ through ‘D’ and “NONE.” Press the
key again to finish editing. Port ‘C’ is the default. If the SmartBoom/SmartRow controller is not
connected to the serial port on a Raven console, this setting must be set to “NONE” for the system to
operate properly.
Console Port
C
RAVEN
HOME
INDUSTRIES