Operator`s manual

Manual No. 016-0171-093 67
SmartBoom Cruizer Interface and Calibration
Sprayer Controller Setup Screen
From the Sprayer screen, touch the Sprayer Controller Setup Icon in the lower left corner to access
the Controller Setup screen.
The sprayer Controller Setup screen allows you to set up SmartBoom control parameters for the job
you are working on. Under most conditions, these settings will be set and not changed.
The Section control allows you to individually enable SmartBoom control for different section numbers.
If for any reason the console needs to be disconnected, uncheck the Console Connected box. Console
connected will be selected if a 4440/4600 console is connected to the SmartBoom.
Touch the Alarms Icon to toggle the alarms on and off.
Touch the Test Icon to test cycle the sections. Each section will individually turn on for 4 seconds and
then turn off. The next section will then be turned on and off and the process will continue until every
sections has been cycled on and off.
Touch the Check Mark to return to the Sprayer screen or touch the Home Icon to return to the home
screen.