Use and Care Manual

Ignition Switch Operation

a. Stop - Disables all functions of the MPV. Must be in this

position to avoid battery drainage when not in use. Battery will

be depleted if left in Electric Mode position.

b. Electric Mode - Drive in forward and reverse.

c. Hybrid Mode - (Gas and Electric) - Mow, tow and drive.

d. Start - Momentary engine starting position

Parking Brake Operation

a. Set the drive mode to Neutral.

b. Push the brake pedal all the way down and hold.

c. Pull the parking brake lever out and hold, then release the

pressure from the brake pedal.

d. Release the parking brake lever. The parking brake will remain

in the locked position.

e. Once set the LED indicator on the dashboard will illuminate and

the brake pedal will stay down when your foot is taken off of it.

f. Ensure the parking brake is set securely before exiting the MPV.

g. Press the brake pedal to release the parking brake.

A sticker on the dashboard indicates where the parking

brake is located.

RAVEN MPV-7100/7100S OWNER’S MANUAL

Drive Controls

Features

WARNING!

ENGINE EXHAUST, SOME OF ITS CONSTITUENTS

AND CERTAIN VEHICLE COMPONENTS CONTAIN

OR EMIT CHEMICALS KNOWN TO THE STATE

OF CALIFORNIA TO CAUSE CANCER AND BIRTH

DEFECTS OR OTHER REPRODUCTIVE HARM.

Ignition

The ignition switch starts the engine and allows selection of

the hybrid and electric modes.

There are four positions on the MPV key switch. Each

position performs a different function.

Throttle (Accelerator) and Brake Pedals

The Throttle controls the acceleration of the MPV in gas

and electric modes. Use the brake pedal to slow down and

stop accordingly in gas and electric drive modes.

Parking Brake

The parking brake must be set before the operator leaves

the seat. If the operator leaves the seat with the engine

running and does not set the parking brake, the engine will

automatically shut off. The parking brake is a pull handle

that is partially hidden by the dashboard.