User's Manual

RV-M50-EC Technical Manual
16
With Bad CRCs: nnn (over-the-air packets with bit errors that were discarded)
Bytes received: nnn (number of bytes this modem received, and sent out its serial port)
Bytes transmitted: nnn (number of bytes this modem received via the serial port, and transmitted
over the air)
Packets send: nnn (number of packets this modem has transmitted over the air.
Retransmissions in the ARQ mode are not counted)
Pkts last minute: nnn (Number of packets received during the last minute)
OK
If there is a hardware problem, there may be one or more hardware error messages listing the error
types (CPU Exceptions, OS Rebooted, or Fatal OS failures). Consult the factory if any of these messages
ever appear.)
4.3 ATST1 Command (GPS Statistics)
The ATST 1 command, will return various information regarding the operation of the GPS features.
4.4 ATST3 Command
The ATST3 command, will return the time and date the firmware was compiled.
4.5 ATST4 Command
The ATST4 command will return internal timers that tell how long the modem has been powered up and
running. All of these timers restart a 0 upon power up.
Run time:
Years: nnn (number of years running)
Days: nnn (number of days running, resets to 0 after one year)
Hours: nnn (number of hours running, resets to 0 after 23 hours, 59 minutes, 59 seconds)
Min: nnn (number of minutes running, resets to 0 after 59 minutes, 59 seconds)
Sec: nnn (number of seconds running, resets to 0 after 59 seconds)
Uptime: nnn (number of seconds running. Does not reset.
OK