manual

nal
rawinternational
rawinternational
rawinternational
rawinternational
rawin
nal
rawinternational
rawinternational
rawinternational
rawinternational
rawin
nal
rawinternational
rawinternational
rawinternational
rawinternational
rawin
nal
rawinternational
rawinternational
rawinternational
rawinternational
rawin
winternational
rawinternational
rawinternational
rawinternational
rawin
ational
rawinternational
rawinternational
rawinternational
rawin
winternational
rawinternational
rawinternational
rawin
ational
rawinternational
rawinternational
rawin
rawinternational
rawinternational
rawin
ational
rawinternational
rawin
rawinternational
rawin
rnational
rawin
rawin
nal
rawinternational
rawinternational
rawinte
nal
rawinternational
rawinternational
rawinternationa
nal
rawinternational
rawinternational
rawinternational
rawinte
nal
rawinternational
rawinternational
rawinternational
rawinternationa
nal
rawinternational
rawinternational
rawinternational
rawinternational
rawin
nal
rawinternational
rawinte
nal
rawinternational
rawinternationa
nal
rawintern
nal
rawinternational
nal
ra
1. Mounting wall plate
Remove security screw from bottom of bracket
and detach front plate (fig. 2). Mount wall plate
(fig. 1) on wall in desired position using screws/
bolts suitable to construction of the wall. (If in any
doubt please consult a qualified builder). Attach
screws/bolts through as many holes/slots as
possible. There are a total of 22 fixing holes on
the back plate, however the minimum amount of
fixings that Raw International recommend is six.
(If in any doubt as to strength of fixings please
consult a qualified builder.)
It is important that the front plates are fixed as
centrally as possible to screen. To help achieve this,
there is a 2mm hole in the centre of each of the
front plates. Line this hole up so it is equal distance
between the top and bottom fixings on the back of
the screen (fig. 2). Once it is lined up, the nearest
fixing hole on the front plates to the top fixing
on the plasma screen are the ones that should
be fixed first (fig. 3) using appropriate screws/
washers/isolators/spacers. Then fix the bottom two
fixings through the slots using appropriate screws/
washers/isolators/spacers. Please use an Allen key
to tighten all four fixings. Only use isolators if back
of screen is not flush with the front plates.
Ensure front plates are situated in a centralised
horizontal position, tighten the screws on the top of
the front plates (fig. 5 overleaf) using a screw driver.
3. Engaging Plasma with the wall
Lift the display (minimum 2 people) with front
plates attached so that the bars engage with the
angled slots on the wall mounting plate (fig. 5
overleaf), the screen is now safely suspended.
2. Attaching front plates to the
plasma screen
Place the screen face down on soft cloth (to
prevent damage) on a flat surface. The fixings you
use is dependent on the make and model of your
screen. There are different sets of fixings supplied
with the bracket. Only ONE set of fixings will be
required. In order to ascertain which set of fixings
will be required, screw fixings in the back of the
screen before attempting to attach front plates.
Only ONE set of fixings will be of the correct
diameter for your screen.
Fig. 1
Mounting holes/slots
Fig. 3
security
screw
2mm
hole
screen
equal distance to 2mm hole
fixings holes on back of screen
steel washer
nylon isolator
front plates
screen
steel fixings
Fig. 3