Operating instructions

ManualsBrandsRayburn ManualsDomestic Appliances200G/L Gas Fired Cooker

THIS APPLIANCE MUST BE INSTALLED IN

ACCORDANCE WITH THE RULES IN FORCE AND

USED ONLY IN A SUFFICIENTLY VENTILATED

SPACE.

The Rayburn 200G/L Gas-Fired Cooker provides cooking

facilities only. A single atmospheric gas burner is

thermostatically controlled at cooking rates, and operates

at a low bypass rate when idling.

The exhaust flue connection of the appliance is in Open

Flue form, operating on natural draught.

Facilities included on the cooker are, a heat graduated

hotplate, main oven and lower oven. A timing programmer

is also available, as an optional extra.

Gas connection 15mm O.D. copper.

Open flue outlet 100mm min.

Electric Supply 50Hz 3 amp fused 230V.

Weight of Appliance 275Kg.

In your own interests, and that of safety, all gas

appliances should be installed by competent persons, in

accordance with the regulations in force.

Appliance

The appliance must be installed on a solid level floor or

base of incombustible material which is capable of

supporting the total weight.

Location

The location chosen for the appliance must permit

installation and the provision of a satisfactory flue and an

adequate space for servicing and air circulation around

the appliance. See Section - Installation of Appliance -

General.

REMEMBER, when replacing a part on this appliance,

use only spare parts that you can be assured conform to

the safety and performance specification that we require.

Do not use reconditioned or copy parts that have not

clearly authorised by AGA.

Installation and Servicing Instructions

for Rayburn 200G/L

Gas Fired Cooker

FOR USE IN GB & IE

PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLING THE APPLIANCE

01/10 EINS 510974

raywarranty@aga-web.co.uk

INTRODUCTION INSTALLATION INSTRUCTIONS

Technical Specification

Natural Gas

Heat Input 5.6kW

Pressure G20 20mbar

G25 25mbar

Injector Size 1.82 Bray 460

Pilot Size 38/36A

Heat Input 6.3kW

Nominal Rate G31 Propane 489 g/h

G30 Butane 497 g/h

Inlet Pressure G31 Propane 37mbar

G30 Butane 28mbar

Injector Size 1.27 Bray 220

Pilot Size 4209

Consumer Protection

As responsible manufacturers we take care to make sure that our

products are designed and constructed to meet the required safety

standards when properly installed and used.

IMPORTANT NOTICE: PLEASE READ THE ACCOMPANYING

WARRANTY. Any alteration that is not approved by AGA, could

invalidate the approval of the appliance, the warranty and could also

infringe the current issue of the statutory requirements.

IMPORTANT:

This appliance could contain any of the materials that are indicated

below. It is the Users/Installers responsibility to ensure that the

necessary personal protective clothing is worn when handling, where

applicable, the pertinent parts that contain any of the listed materials

that could be interpreted as being injurious to health and safety, see

below for information.

Firebricks – when handling use disposable gloves.

Fire cement – when handling use disposable gloves.

Glues and sealants – exercise caution – if these are still in liquid

form use face mask and disposable gloves.

Glass Yarn, Mineral Wool, Insulation Pads, Ceramic Fibre,

Kerosene Oil – may be harmful if inhaled, may be irritating to skin,

eyes, nose and throat. When handling avoid inhaling and contact

with skin or eyes. Use disposable gloves, face masks and eye

protection. After handling wash hands and other exposed parts.

When disposing of the product reduce dust with water spray, ensure

that parts are securely wrapped.

Summary of content (12 pages)

PAGE 1
Installation and Servicing Instructions for Rayburn 200G/L Gas Fired Cooker FOR USE IN GB & IE PLEASE READ THESE INSTRUCTIONS BEFORE INSTALLING THE APPLIANCE Consumer Protection As responsible manufacturers we take care to make sure that our products are designed and constructed to meet the required safety standards when properly installed and used. below for information. Firebricks – when handling use disposable gloves. Fire cement – when handling use disposable gloves.
PAGE 2
Fig. 1 GAS SUPPLY FLUE SYSTEM Installation Gas pipes Do not use pipes of a smaller size than the appliance gas connection. The complete installation must be tested for soundness and purged. The following notes are intended to give general guidance:The cross-sectional area of the flue serving the cooker must not be less than the area of the flue outlet of the cooker, and at least 3m high from the floor level. If flue pipe is to be used it must not be less than 100mm internal diameter.
PAGE 3
EFFECT OF AN EXTRACTION FAN COMBUSTION AIR SUPPLY If there is any type of extract fan fitted in the same room as an appliance, there is a possibility that if adequate air inlet area from outside is not provided, spillage of the products from the appliance flue could occur when the extract fan is in operation. Where such installations occur, a spillage test must be carried out as follows:- By holding a smoke match so that the flame is approximately 3mm up inside the lower edge of the draught diverter.
PAGE 4
Preliminary Installation The appliance is delivered assembled with the exception of the following items which are supplied separately packed and require assembly. 1. Draught Diverter Assembly See Fig. 4. 2. Appliance Rear Distance Bracket (For use when appliance is Bracket installed 25mm away from a rear wall of combustible material). See Fig. 5. 3. Insulating Covers. 4. Handrail Brackets and Handrail Site Location 1.
PAGE 5
6. The handrail brackets are held on the front ends of the cooker top-plate casting. Remove the travel nuts and replace with handrail brackets ensuring the fibre protecting washers are in position. Insert the handrail with fitted endcaps into the brackets, positioning them correctly, tighten the locating bolts. (See Fig. 6A). LIGHTING THE BURNER See Fig. 7 IMPORTANT: IF THE PILOT IS EXTINGUISHED FOR ANY REASON, ALWAYS WAIT AT LEAST 3 MINUTES BEFORE ATTEMPTING TO RELIGHT. 1.
PAGE 6
Fig.
PAGE 7
HOW TO OPERATE COOKER CONTROL METHOD OF APPLIANCE CONTROL Overnight and when not required for cooking, leave thermostat knob D at LOW position. To increase the temperature of the oven or hotplate, turn the thermostat knob D to required temperature setting. See separate programmer operating instructions to set the programmer if fitted. The cooker burner provides heat for two ovens and hotplate. A main gas service cock is incorporated below the cooker burner control valve.
PAGE 8
Servicing Instructions To Clean Heat Exchanger and Flueways a. Replace the main and pilot burner assembly as previously described. b. Place a layer of paper on combustion chamber baseplate. c. Examine insulation panels for any sign of deterioration, replace if necessary. d. Remove layer of paper with fallen debris. e. Check that oven top is free of deposit and brush in between ribs on hotplate underside. f. Examine soft rope seal located on the underside of hotplate baffle plate, Replace if worn or frayed.
PAGE 9
4. Spark Electrode a. Remove burner assembly as detailed in Servicing Schedule. b. Remove HT spark lead from spark electrode. c. Remove spark electrode. d. Replace with new spark electrode taking care not to put any strain on the ceramic body replace screw to secure position. e. Reconnect the HT spark lead. f. Reassemble burner assembly into cooker. behind the thermostat. n. Now reverse the order of the above to reassemble (h-b). 7. Gas Valve a. Remove burner assembly as detailed in Servicing Schedule. b.
PAGE 10
Fig.
PAGE 11
PAGE 12
For further advice or information contact your local distributor/stockist With AGA’s policy of continuous product improvement, the Company reserves the right to change specifications and make modifications to the appliance described at any time. Manufactured by AGA Station Road Ketley Telford Shropshire TF1 5AQ England www.rayburn-web.co.uk www.agacookshop.co.uk www.agalinks.