User's Manual

81
10. Maintenance
(1) Maintenance
 Maintenance of the detector should be done by an authorized
service provider
 If the Detector Panel is defective, the detector will be
returned as is to the manufacturer for repair
 Clean the equipment with a dry soft cloth, or a soft cloth
lightly moistened with mild detergent solution. Do not use any
type of solvent, such as benzene
 This equipment and accessories are to be disposed of safely
after the life span of them and national regulation must be
observed.
 For safety reasons, be sure to inspect the instrument before
using it. In addition, carry out a regular inspection at least
once a year.
 Arrange the detector and power supply link cable to prevent
the damage of the cable’s rubber tube. For example, do not
press the cable under the legs of the table or the people.
 This equipment must only be connected to a supply mains
with protective earth.
(2) Cleaning
Cover
Clean the cover by the left warning box, if it is dirty.
CFRP of Detector
Wipe the CFRP plate of the sensor unit with ethanol or
glutaraldehyde solution to disinfect it each time a different patient
uses the instrument, in order to prevent infection. If you are using
disinfectant other than those specified above, or you are mixing
another disinfectant with ethanol, please also consult a specialist,
because they may harm the CFRP plate.
For
safety
reasons, be
sure to turn OFF the
power of the
detector when the
following
inspections are
going to be
performed.
Otherwise, it may
result in electric
shock.
When the
instrument
is going to
be cleaned, be sure
to turn OFF the
power of each
instrument, and
unplug the power
cable from the AC
outlet. Otherwise,
fire or electric shock
may result.