User Manual

014

130312

Radio Frequency compliance

FCC/IC Notice (U.S.A and CANADA)

 FCC Part 15 Subpart C §15.247 and IC RSS-210 Issue 7

FCC Part 15 Subpart E §15.407 and IC RSS-210 Issue 7

 FCC ID: QIIRY1417WCA

5.15- 5.25 GHz band is restricted to indoor operations only.

Host device of the approved module shall be marked with the following

item: Contains Transmitter Module FCC ID: PPD-AR5BHB116

Compliance with FCC requirement 15.407(c)

Data transmission is always initiated by software, which is the passed

down through the MAC, through the digital and analog baseband, and

finally to the RF chip. Several special packets are initiated by the MAC.

These are the only ways the digital baseband portion will turn on the RF

transmitter, which it then turns off at the end of the packet. Therefore,

the transmitter will be on only while one of the aforementioned packets

is being transmitted. In other words, this device automatically

discontinues transmission in case of either absence of information to

transmit or operational failure.

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not cause

harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

FCC CAUTION

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate the

equipment. This transmitter must not be co-located or operated in

conjunction with any other antenna or transmitter.

When installing it in a mobile equipment

This equipment complies with FCC radiation exposure limits set forth for

an uncontrolled environment and meets the FCC radio frequency (RF)

Exposure Guidelines in Supplement C to OET65. This equipment has

very low levels of RF energy that it deemed to comply without maximum