User's Manual

Remote Display
18
www.tacktick.com
3 Setup and Calibration
3.1 Entering Setup and Calibration Mode
To enter the Setup and Calibration menu press and hold for 2 seconds
the button.
Note: It is not possible to enter setup mode while the Race Timer is
currently visible on a single item display page. Scroll to a different page
in order to enter setup.
3.2 Setup and Calibration Chapter and Page operation
On entering setup mode a list of chapters is displayed, with the active
chapter marked with the cursor .
To change the active chapter:
Press the button repeatedly until the desired chapter title is
alongside the cursor.
To enter the active chapter:
Press the button. A list of pages is displayed with the active page
marked with the cursor .
Press the button to return to the list of chapters.
To change the active page:
Press the button repeatedly until the desired page title is alongside
the cursor.
To enter the active page:
Press the button. A list of parameters and current settings is
displayed with the active parameter over the cursor .
Press the button to return to the list of pages.
To change the active parameter:
Press the button repeatedly until the desired parameter title is over
the cursor .
3.3 Editing Parameter Values
Parameter values may be one of four types:
A user editable numeric value (for example, the shallow depth alarm
may have the value 3.2).
A resetable numeric memory value (for example the minimum depth
memory can be reset to the current depth).
A list of options (for example, the speed units parameter may have the
values KNOTS/KPH/MPH).