User's Manual
Table Of Contents
- 1 Notices
- 2 Introduction
- 3 Operation
- 3.1 Display and controls
- 3.2 Turning the transceiver on
- 3.3 Display layout
- 3.4 Main operating screens
- 3.5 Target list
- 3.6 Own vessel and voyage data
- 3.7 Own dynamic data
- 3.8 Received messages
- 3.9 Alarms screen
- 3.10 Target plot screen
- 3.11 Working with AIS text and Safety Related Messages (SRMs)
- 3.12 Handling alarms
- 3.13 Entering text
- 3.14 Long range messages
- 3.15 Passwords and security
- 3.16 The configuration menu
- 3.17 Tanker mode
- 3.18 Units display - speed and distance
- 4 Installation
- Figure 32 Typical AIS transceiver connection
- 4.1 What’s in the box?
- 4.2 Preparing for installation
- 4.3 Installation procedures
- Figure 34 AIS transceiver dimensions
- Figure 35 Mounting the AIS transceiver
- Figure 36 Panel mounting the AIS transceiver
- Figure 37 Junction box dimensions
- Figure 38 Mounting the junction box
- Figure 39 GPS antenna location
- Figure 40 GPS antenna connection
- Figure 41 VHF antenna installation
- Figure 42 VHF antenna connection
- 4.4 Connecting the equipment
- 4.5 Configuring the AIS950 Transceiver
- 4.6 Changing the password
- 4.7 Confirming correct operation
- 4.8 Regional area settings
- 5 Technical Specifications
- 6 Technical reference
- 7 Drawings
- 8 Installation record
Installation
Page 50
To create the new area setting press the ‘New' function key and the edit screen shown in Figure 51 will be
displayed.
Figure 51 Regional area editing screen
1. The scroll wheel can now be used to scroll to the field to edit.
2. Select the field by pushing the scroll wheel or pressing the 'Edit’ function key.
3. Ente
r a value, or select from a list of possible values using the scroll wheel.
4. Press the ‘OK’ or ‘Cance
l' functio
n key to confirm or cancel the entry.
5. Repeat the process 1 - 4 for each field to be edited.
6. Press the ‘Bac
k/Save’ function
key to save the regional area setting and return to the area settings list
7. You will be prompted to confirm storage of the regional area setting with the display
shown in Figure 52.
8. After confirmation of
the regional settings the settings are stored and may take effect immediately de-
pending on the location of the vessel.
Figure 52 Regional area settings confirmation screen
4.8.2 Editing an existing regional area setting
To edit an existing regional area setting press the ‘Menu' key and select the
‘Installation' and then the ‘Regional
areas’ sub-menu. The display now shows a list of the current regional area settings as shown in Figure 50. Use
the scroll wheel to scroll to and select the reg
ional area setting entry to be edited, then follow the instructions
for creating a new regional area setting in section 4.8.1.
13:20:47
EDIT REGIONAL AREA:
In Use: No
Time of In Use: --:--:--
Info Source: Not Available
Channel A: 2087
Channel B: 2088
Channel A BW: Default
OK
GPS
INT
Back
13:20:47
SAVE REGIONAL AREA:
Are you sure you want to save the
edited Regional Area?
Area settings may take effect
immediately!
OK
GPS
INT
No Yes