Installation Instructions Part 1

59 Chapter 5: Installation and mounting
Remember
Where constraints on the installation prevent any of the above
recommendations:
• Always allow the maximum separation possible between differ-
ent items of electrical equipment.
• This will provide the best conditions for EMC performance for
the installation.
Suppression ferrites
Raymarine cables may be fitted with suppression ferrites. These
are important for correct EMC performance. Any ferrite removed to
facilitate installation must be replaced in the original position imme-
diately after the installation is complete.
• Use only ferrites of the correct type, supplied by Raymarine au-
thorized dealers.
Connections to other equipment
If Raymarine equipment is to be connected to other equipment
using a cable not supplied by Raymarine, a Raymarine suppres-
sion ferrite MUST always be attached to the cable near the
Raymarine unit.
5.2 GPM400 Processor module
D10100-1
Minimum radius
bend of cable
(100mm)
Minimum ventilation
clearance of XXX mm
around total perimeter
Cable clip
Air vents
335 mm (13.2 in)
230 mm (9.0 in)
125 mm (4.92 in)