Installation Instructions Part 2

83 Chapter 8: Commissioning

8.3 Radar setup

2 scanner systems

The system may have 2 digital scanners connected. You can select

the scanner to be used for each radar window.

For 2 scanner systems you must repeat the instructions in this

(Radar setup) section, once for each scanner.

Initialize radar and set to transmit

You will need to:

• Initialize the radar

• Select a scanner (2 scanner systems only)

• Set radar to transmit

To initialize the radar

Select a Radar page by either:

i. Press the PAGE key to select from the current page set.

ii. Press and hold the PAGE key to select from all available

pages.

The Radar scanners will now initialize in standby mode, this pro-

cess will take approximately 70 seconds.

If the radar fails to initialize, refer to Chapter 9:

Troubleshooting. Page 91.

To assign scanners (2 scanner systems only)

For 2 scanner systems you must select which scanner is to be used

for the current radar view.

Scanners are listed by serial number (or name if assigned).

1. Select the appropriate scanner from those displayed.

2. Press OK when done.

Note: The EDIT NAME softkey allows you to assign a name to

each scanner connected

Electromagnetic energy

The radar scanner transmits electromagnetic

energy. Ensure all personnel are clear of the

scanner before switching to Tx (transmit mode).

Radar 1 (long range)

D10513-1

Radar 1 Radar 2Radar 2 (short range)

Radar 1

Radar 2

D10340-1

RADAR SETUP

ASSIGN SCANNERS