Installation Instructions Part 2

85 Chapter 8: Commissioning

2. Note the position of the object on the radar display. If the target

is not under the Ships heading marker (SHM), there is an align-

ment error and you will need to carry out bearing alignment

adjustment.

To adjust the bearing alignment

With a radar window active select the bearing alignment menu:

From the menu:

1. Press the BEARING ALIGNMENT softkey.

2. Use the rotary control to place the selected target under the

SHM.

3. Press OK when complete.

Parking settings (open array scanners)

To ensure the scanner parks (rests) in the correct position when

rotation stops, you may need to adjust the radar offset angle.

To adjust radar parking settings

From the Radar setup menu (radar in standby mode):

1. Select the PARKING OFFSET option, then adjust the offset

angle required to park the radar so that the antenna comes to

rest facing forward (you should see the Raymarine logo wording

from the front of the boat) when you place it in either standby or

switch it off.

2. Press OK when complete.

8.4 GPS checks

The GPS is required to show your boat position on the chart. You

can set up your GPS and check its status using the GPS status

icons and the GPS Status page of the Setup menu.

Check the GPS Status icon

This is located in the top right hand corner of the screen.

If NO FIX is displayed refer to the GPS status page (below) and

Troubleshooting section on page 95.

GPS Status page

D10343-1

RADAR SETUP

BEARING ALIGNMENT

D10346-1

D10344-1

GPS STATUS