Installation Instructions Part 2

87 Chapter 8: Commissioning
• Valid depth and frequency values on screen
If any of the above are not present this could indicate a fault. Refer
to
Chapter 9: Troubleshooting. Page 91.
Fault indications:
No Data
This is displayed if the system cannot detect a compatible DSM
sounder with appropriate transducer.
Invalid custom configuration
Indicates an invalid manual override of switch settings at the trans-
ducer. Refer to your DSM and Transducer documentation for
further information.
8.6 Set up video
To ensure correct operation of the video and entertainment system
you should setup and test all video and audio channels.
Before proceeding ensure that the video sources are operating. For
audio you should ensure that the amplifier is turned on with the
appropriate input selected.
Check the video and audio output
You will need to:
• Set up and select a video page
• Set up the video inputs
To set up a video page
1. Open the system Setup menu.
2. Open the Select Page Set screen.
3. Highlight the page set you want to edit.
4. Press the EDIT PAGE SET softkey:
5. Follow the on-screen instructions and select the video page
type as appropriate.
6. Press OK.
To select a video page
• Press the PAGE key to select from the current page set.
OR
• Press and hold the PAGE key to select from all available page
sets.
The audio (associated with input 4) will be heard through the con-
nected amplifier or television.
To set up video inputs
This menu provides the following options:
• Setup video cycle
You may set up display cycles for multiple video sources.
• Setup softkey shortcuts
You can set up the softkeys used to view the video channels on
the monitor.
• Configure video system
Set up S-Video and other video options (S-Video is only avail-
able on input 4). See
Configure the video system .
• Reset GVM
Reset all options associated with the GVM400 video server(s)
to the factory default settings.
D10352-1
MENU
VIDEO SETUP MENU