Installation Manual

Note: Retain the protective cap, for use if the open array is removed from

the pedestal in the future. If the pin is damaged during the following

operation you should contact your service dealer.

3. Move the antenna mounting bracket so it sits on the Port to

Starboard axis of the digital radar. Lift the open array into position,

taking care it is in the correct orientation and that the threaded

alignment guides are fitted. Carefully align, then slowly lower the

array.

Note: The antenna mounting bracket is designed so that the array can

only be fitted to the pedestal in the correct orientation.

4. Once the antenna is seated, remove the alignment guides.

5. Grease the four securing studs with Denso paste (supplied).