User's Manual
Table Of Contents
- Thank You!
- Important Information
- Table of Contents
- Introduction
- 1. Installation Preparation
- 2. Choose the Mounting Location
- 3. Test Route the Cables
- 4. Install the Scanner
- 5. Route the Cables
- 6. Connect to Power and Ethernet
- 7. Test the Installation
- Two Year Limited Warranty & Service Policy
- Maintenance
- Troubleshooting
- Specifications
- Contact Humminbird
5
Installation Preparation
2. Choose the Mounting Location
It is important to consider the following information when installing the Radar scanner on the vessel. The
Radar scanner must be mounted where it is:
• Near the vessel's centerline
• Above head height
• Clear of large objects such as the flybridge, large engine stacks, searchlights, horns, masts, etc.
• At least 3 feet (1 m) from a magnetic compass or other scanners
• Away from heat and fumes
• On a stable platform that is capable of securely supporting the scanner under seagoing conditions
• Easily accessible
WARNING! Do NOT install the radar in a location that exposes passengers and
crew to the radar beam. Do NOT mount the radar where it could radiate on any person.
CAUTION! Working at higher elevations may become necessary while installing
the scanner unit. Observe safety measures and take sufficient precautions to avoid
personal injury or damage to the equipment.
Determining the Mounting Location
rear view side view side view rear view
ation
CHIRP_Radar_Install_Manual_532523-1EN_A.qxp_Layout 1 8/11/16 10:48 AM Page 5