User's Manual
Table Of Contents
- Thank You!
- Important Information
- Table of Contents
- Introduction
- 1. Installation Preparation
- 2. Choose the Mounting Location
- 3. Test Route the Cables
- 4. Install the Scanner
- 5. Route the Cables
- 6. Connect to Power and Ethernet
- 7. Test the Installation
- Two Year Limited Warranty & Service Policy
- Maintenance
- Troubleshooting
- Specifications
- Contact Humminbird
Mounting Base
The Radar scanner can be installed directly to a roof or other flat surface. The mounting location must be
secure enough to support the Radar scanner under seagoing conditions. You can also use a mounting
bracket (separate purchase required). Be certain to keep the water drain tube clear, which is located at the
bottom of the scanner unit.
NOTE: If the mounting bracket or surface has a curvature of more than 5/64" (2 mm), use spacers with the
mounting bolts to prevent stress on the scanner housing.
Access
Access to the under side is required for installation of the mounting bolts.
C
ompensating for Bow Rise
wedge or washers
Incorrect Mounting Base
Correct Mounting Base
mounting surface is clear and doesn’t trap water Do not mount on a surface with an edge that might trap water.
8
Installation Preparation
Sai
Add
mas
Revi
•
•
•
•
CHIRP_Radar_Install_Manual_532523-1EN_A.qxp_Layout 1 8/11/16 10:48 AM Page 8