User's Manual
Table Of Contents
- Thank You!
- Important Information
- Table of Contents
- Introduction
- 1. Installation Preparation
- 2. Choose the Mounting Location
- 3. Test Route the Cables
- 4. Install the Scanner
- 5. Route the Cables
- 6. Connect to Power and Ethernet
- 7. Test the Installation
- Two Year Limited Warranty & Service Policy
- Maintenance
- Troubleshooting
- Specifications
- Contact Humminbird
i
Rad
Pos
Ser
Com
Add
Thank You!
Thank you for choosing Humminbird®, the #1 name in marine electronics. Humminbird has built its reputation
by designing and manufacturing top-quality, thoroughly reliable marine equipment. Your Humminbird is
designed for trouble-free use in even the harshest marine environment. We encourage you to read this
installation manual completely in order to get the full benefit from all the features and applications of your
Humminbird product.
Contact Humminbird Customer Service at humminbird.com or call 1-800-633-1468.
Important Information
Review the following important information before proceeding with the installation.
Certified Installation
WARNING! Humminbird recommends certified installation by a Humminbird approved installer. Contact
your Humminbird dealer for further details, and refer to the warranty information included at the end of this
manual.
WARNING! This product must be installed and operated in accordance with the instructions provided.
Failure to do so could result in personal injury, damage to your vessel and/or poor product performance.
CAUTION! Installation and radar tuning should only be performed by a qualified radar service technician.
Potential Ignition Source
WARNING! This product is NOT approved for use in hazardous and/or flammable atmospheres. Do NOT
install in a hazardous and/or flammable atmosphere (such as in an engine room or near fuel tanks).
High Voltages
HIGH VOLTAGE WARNING! Dangerously high voltages are present within the scanner unit. There
are no internal connections or adjustments necessary for installation. Do NOT remove any covers or
otherwise attempt to access internal components, unless specifically instructed in the documentation
provided. The cover should be removed only by a qualified radar service technician. Technicians must
exercise extreme care when working inside the unit.
WARNING! Connecting this product to a voltage supply greater than the specified maximum rating may
cause permanent damage to the unit. Refer to the Specifications section for voltage rating.
CHIRP_Radar_Install_Manual_532523-1EN_A.qxp_Layout 1 8/11/16 10:48 AM Page i