User's Manual
Table Of Contents
- Thank You!
- Important Information
- Table of Contents
- Introduction
- 1. Installation Preparation
- 2. Choose the Mounting Location
- 3. Test Route the Cables
- 4. Install the Scanner
- 5. Route the Cables
- 6. Connect to Power and Ethernet
- 7. Test the Installation
- Two Year Limited Warranty & Service Policy
- Maintenance
- Troubleshooting
- Specifications
- Contact Humminbird
3. Install the Radar Scanner
Use the following instructions to install the Radar scanner on your vessel. Confirm you have read the
mounting requirements in the section Choose the Mounting Location.
1. Place the Radar scanner on the mounting surface.
2. Level Mounting Surface: Confirm the Radar scanner is flush against the mounting surface.
Angled Mounting Surface: If you are installing the Radar on a planing vessel (or other angled surface),
place a wedge (shim) under the rear of the Radar scanner so that the beam points slightly down in the
forward direction when the boat is at rest. This will compensate for the bow rising at cruising speed.
3. Install one spring washer and one flat washer on each bolt as indicated in the illustration Mounting the
Scanner Unit.
4. Insert each bolt through the drilled bolt holes in the mounting surface and into each threaded bolt hole
on the Radar scanner. Hand-tighten only.
5. Confirm the bolts have a minimum insertion in the Radar scanner base of 5/8" (16 mm) and a maximum
of 7/8" (22 mm) (allowing for washers).
CAUTION! The Radar scanner may be damaged if bolts protrude through the mounting surface
more than 7/8" (22 mm).
Mounting on an Angled Surface (or Planing Vessel)
install a wedge
or riser block
bolts and washersmounting surface
with planing angle
bolts and washers
Mounting on a Level Surface
level mounting surface
The radar scanner should be flush
against the mounting surface.
15
Installation
CHIRP_Radar_Install_Manual_532523-1EN_A.qxp_Layout 1 8/11/16 10:48 AM Page 15