User's Manual

3. Connect to the Control Head
Refer to your control head installation guide for additional information and instructions about connecting
cables.
Connect to ONIX
1. Insert the data cable connector into the Ethernet port on the control head.
2. Hand-tighten the screw nut on the cable to secure the connection.
3. Confirm there is enough cable slack to allow for the control head to pivot through its full tilt range and for
connecting or disconnecting the cables.
Connect to HELIX
To connect the Radar scanner to a HELIX control head, a separate purchase AS EC QDE Ethernet Adapter
Cable is required.
1. Connect the data cable connector to the AS EC QDE adapter cable connector. Hand-tighten the screw nut
on the cable to secure the connection.
2. Insert the AS EC QDE adapter cable connector into the Ethernet port on the control head.
3. Confirm there is enough cable slack to allow for the control head to pivot through its full tilt range and for
connecting or disconnecting the cables.
R
adar Scanner Power Cable
red cable (positive)
black cable (negative)
cable connector
20
Connect to Power and Ethernet
Con
Use
insta
1.
2.
3.
4.
5.
CHIRP_Radar_Install_Manual_532523-1EN_A.qxp_Layout 1 8/11/16 10:48 AM Page 20