User's Manual
Table Of Contents
- Thank You!
- Important Information
- Table of Contents
- Introduction
- 1. Installation Preparation
- 2. Choose the Mounting Location
- 3. Test Route the Cables
- 4. Install the Scanner
- 5. Route the Cables
- 6. Connect to Power and Ethernet
- 7. Test the Installation
- Two Year Limited Warranty & Service Policy
- Maintenance
- Troubleshooting
- Specifications
- Contact Humminbird
21
Connect to Power and Ethernet
ting
d for
pter
w nut
d for
Connect to an Ethernet Switch
Use the following instructions to connect the data cable to an Ethernet Switch. See the Ethernet Switch
installation guide for information about connecting cables.
1. Connect the data cable connector to an available port on the Ethernet Switch. Hand-tighten the screw nut
on the cable to secure the connection.
2. Connect an Ethernet cable to an available port on the Ethernet Switch.
3. Insert the Ethernet cable connector into the Ethernet port on the control head.
4. If the cable connector has a screw nut, hand-tighten the screw nut to secure the connection.
5. Confirm there is enough cable slack to allow for the control head to pivot through its full tilt range and for
connecting or disconnecting the cables.
NOTE: If the cables are too short for your application, extension cables are available. Visit our Web site at
humminbird.com.
CHIRP_Radar_Install_Manual_532523-1EN_A.qxp_Layout 1 8/11/16 10:48 AM Page 21