Owner's Handbook

Chapter 2: Installing the Scanner 29
4. Slide the cable through the gland nut, washer and grommet, then
into the base. Carefully remove the heat shrink shroud, ensuring
that you do not damage the cable.
5. Ensure the exposed braid is positioned in the p-clip to provide an
earth, then clamp securely into position.
Secure the cable at the entrance to pedestal base using the plastic
cable clamp.
Hand tighten the cable gland nut.
.
6. The cable is supplied prepared and ready to fit to the signal and
power connectors. If you need to cut the cable to length, strip off
the protective outer sleeve then use the supplied kit to prepare the
cable as detailed in the following illustration.
D4575-3