User's Manual

Chapter 4: Operations 23
4.13 Using the Scan Modes
The RAY101 is equipped with three types of scan options: All Scan, Saved
(Memory) Scan and Priority Scan. If there are no channels in memory, the
default is All Scan.
This function automatically searches for broadcasting channels. If a TX
signal is received, the scan stops on the receiving channel as long as it is
present. If the signal is lost for five seconds, the radio resumes scanning.
During the Scan Modes:
• Press the Channel UP/DOWN key to change the scan direction.
UP increments the channel while DOWN decrements it.
• Press and release SCAN/SAVE to terminate the SCAN mode and return to
the last-used channel
• DW/TRI and WX/BAND keys will not function and sounds an error
beep if pressed
All Scan
Press and release the SCAN/SAVE key when no channels are stored in
memory to activate the All Scan function.
The SCAN indicator appears on the LCD during All Scan.
In All Scan mode, all channels in the
channel set are scanned in sequence,
assuming no channels have been stored in
memory. After the last channel number has
been scanned, the cycle repeats.
All Scan is demonstrated in the figure to
the left.
81229_1.book Page 23 Wednesday, November 12, 2003 2:39 PM