Product specifications

58
RayChart 620
6.2 Setting Up the Data
The RayChart 620 allows you to set up a number of parameters that
control the way it operates. These are accessed from the SET UP
menu.
The SET UP menu options control the following:
• System set up
• Navigation set up
• Chart Plotter set up
• Alarms and timers set up
• Position fixer initial settings and reset
• Memory C-Card transfers
Before you make any changes:
1. Check the lists of parameters and options provided in the tables in
this section.
2. Decide what changes, if any, you wish to make.
3. Fill in the required settings in the spaces provided in the tables.
Once you have done this, follow the instructions given below to make
the changes.
Setting the Defaults
➤ To set the setup defaults:
1. Press the MENU key to display the SET UP menu above the right
hand soft key. The option you used last is currently highlighted.
2. Use the trackpad or SET UP soft key to highlight the required menu
option, and press ENTER.
The requested set up menu is displayed, listing the parameters and
their current settings and, for some items, menus of further
parameters. For example, the SYSTEM set up menu is shown on
the following page.
3. Use the up and down trackpad controls to move the selection bar
up and down the list.
4. When the required parameter or menu is highlighted, press
ENTER.
For menus, a further menu of parameters is displayed. Repeat
steps 3 and 4 to select a parameter.