User Manual

34 ST1000 Plus & ST2000 Plus Tiller Pilots
CAUTION:
As the tiller pilot is capable of generating high pushrod loads, you
MUST:
• drill all holes to the specified size and reinforce where necessary
• allow the epoxy to harden thoroughly before applying a load
Installation accessories
If you are not able to install the tiller pilot directly onto the cockpit seat or tiller as
described, one (or a combination) of the following installation accessories:
• pushrod extensions
• tiller brackets
• cantilever sockets
• pedestal sockets
• alternative tiller pins
Pushrod Extensions
If you need to increase the pushrod length (because of the distance from the
mounting socket location to the center line), use a Raymarine pushrod extension.
Identifying the correct pushrod extension
1. Clamp the tiller on the boat’s center line.
2. Measure dimension C.
3. Select the appropriate pushrod extension length (and part number) using the
following table.
Dimension C Pushrod extension length L Part no.
589 mm (23.2 in) Standard dimension -
615 mm (24.2 in) 25 mm (1 in) D003
640 mm (25.2 in) 51 mm (2 in) D004
665 mm (26.2 in) 76 mm (3 in) D005
691 mm (27.2 in) 102 mm (4 in) D006
716 mm (28.2 in) 107 mm (5 in) D007
742 mm (29.2 in) 152 mm (6 in) D008
81130_7.book Page 34 Friday, December 13, 2013 12:58 PM