User Manual

Chapter 4: Installing the Tiller Pilot 35

Mounting the pushrod extension

To mount the pushrod extension:

1. Unscrew the end of the tiller pilot’s pushrod.

2. Screw the extension into the pushrod.

3. Screw the pushrod end into the pushrod extension.

Tiller brackets

If the tiller is higher or lower than the mounting socket, you can use a Raymarine

tiller bracket to vary the tiller pin offset so the pilot is horizontal.

Identifying the correct tiller bracket

1. Clamp the tiller on the boat’s center line.

2. Measure dimension D (if the pushrod is above the tiller) or dimension E (if the

pushrod is below the tiller).

3. Select the appropriate bracket from the following table:

Dimension D

(pushrod below tiller)

Dimension E

(pushrod above tiller)

Bracket

part no.

25 mm (1 in) 51 mm (2 in) D009

51 mm (2 in) 76 mm (3 in) D010

76 mm (3 in) 102 mm (4 in) D011

D3193-2

81130_7.book Page 35 Friday, December 13, 2013 12:58 PM