User Manual

Chapter 4: Installing the Tiller Pilot 39
Pedestal socket mounting
If you need to raise the height of the mounting socket to keep the tiller pilot
horizontal, use a Raymarine pedestal socket assembly.
Identifying the correct pedestal socket
1. Clamp the tiller on the boat’s center line.
2. Establish the standard control dimensions A and B.
3. With the tiller pilot horizontal, measure dimension G.
4. Select the appropriate pedestal socket assembly from the table.
Mounting the pedestal socket
1. Mark the mounting ring’s position on the cockpit seat or counter.
2. Ensure that control dimensions A and B are correct.
Dimension G Pedestal socket length L Part no.
64 mm (2.5 in) Standard dimension -
102 mm (4.0 in) 38 mm (1.5 in) D026
114 mm (4.5 in) 50 mm (2.0 in) D027
127 mm (5.0 in) 64 mm (2.5 in) D028
140 mm (5.5 in) 76 mm (3.0 in) D029
153 mm (6.0 in) 89 mm (3.5 in) D030
D3197-2
L
G
81130_7.book Page 39 Friday, December 13, 2013 12:58 PM