Operation Manual

2) When 16/9 key is pressed and released again during “P” is diplayed, Alerm 1 is heard
and the channel will be returned to the privious Working CH. When the channel is
changed by UP/DOWN key during Priority CH is displayed, “P” display will be
eliminated and Workimg CH will be in use.
3) When 16/9 is continueously pressed for over 2 seconds, Alerm 1 is heard and Priority
channel can be changed either 16CH or 9CH.(When Priority CH is 16CH, it can be
changed to 9CH and when Priority CH is 9CH,it can be changed to 16CH.)
1.3.8 Channel Memory
1) The RAY53 has the capability of memorizing all US,International and Canadian
Channels. The channels memorized will be scanned in the Memory Scan mode.
2) Channel Memory: When SCAN/MEM key is pressed and held for over 3 seconds,the
audible beep sound 1 is heard and the selected current channel can
be put into memory.
When the displayed channel on the LCD is memorized, “MEM” is
displayed on the LCD.
Memory Clear : To press and hold for 3 seconds when the memory channel is
stored, the audible beep sound 1 is heard and the channel can be
cleared
When the displayed channel is not memorized,”MEM” is not
displayed on the LCD.
1.3.9 Scan Modes
The RAY53 is equipped with two types of scan options, All-scan and Memory Scan. How these
options are accessed is dependent upon whether there are any channels stored in memory.
1) All-Scan mode
If no channels are stored in memory,when the SCAN/MEM key is pressed and
released, the audible beep sound 1 is heard and ”SCAN” will begin to flash on the LCD for
three seconds. If no other keys are pressed in these three seconds,the radio will begin
scanning all channels(except weather channels) as long as no signal is received. If a signal is
received,the scan will stop on the receiving channel. If the signal is lost for five seconds, the