Operation Manual

-. If the number is entered correctly, the entered number becomes Own Ship’s
MMSI by pressing DSC key for 2 seconds and the audible beep sound 1 is heard,then
the DSC mode is exited and returned to Working CH.
4. Entry of number is done by Channel Selection knob. The number cannot be input by
UP/DOWN key on the Microphone.
The stored data can be memorized only by DSC key
The stored data cannot be memorized by the other key operations and cannot be done
when the power is turned off on the way.
5. The way to CLEAR Own ship’s ID No.
To turn the unit on with pressing and holding SCAN/MEM + 16/9 key simultaneously.
The audible beep sound 1 is heard and “CL” is displayed at Channel Display(Large).
2) Individual Ship’ Call”
1.
“
Individual Ship’s Call” specifies other Ship’s Number and the channel number.
Unless Own Ship’s MMSI ID is entered, Individual Ship’s Call cannot be used.
2. When SCAN/MEM key and WX/INT key are simultaneously pressed and
released, Individual Ship’s Call will be in use.
---
Æ
“DSC” is displayed on the LCD which means the unit is in DSC mode.
---
Æ
Channel 70 is displayed at Channel Display(Large)
(Programming for PLL data of 70CH.)
---
Æ
“In” is displayed at Channel Display(Small) which means the unit is in
Individual Ship’s Call mode.
3. When SCAN/MEM key (“DSC” key) is pressed and released, the audible beep sound 1 is
heard and the other ship’s Number can be set.
-. “0” is displayed at Channel Display(Large) on the LCD and “1” is displayed at
Channel Display(Small) on the LCD.