Operation Manual

6’ If the operator would like to resistor Other ship’s MMSI No.only without attempt of
transmission, the last used(before registration of MMSI) CH will be displayed by
pressing 16/9 key at this stage.
7. -. Working Channel can be selected by rotating Channel Selection knob.
-. When SCAN/MEM key(“DSC” key) is pressed and released, the audible beep sound
is heard and the selected number can be memorized as Working Channel number.
8. If the operator would like to resistor Other ship’s MMSI No.only without attempt of
transmission, the last used(before registration of MMSI) CH will be displayed by pressing
16/9 key at
9. After entry of “Channel number”, “Individual Ship’s Call” is ready to transmit.
----
Æ
“TX” is flashing on the display(Instruction to be ready to transmit)
----
Æ
Channel 70 is displayed at Channel Display(Large)
(Programming for PLL data of 70CH.)
----
Æ
“In” is displayed at Channel Display(Small) (Instruction for Individual Ship’s
Call)
-. While “TX” is flashing,Individual Ship’s Call can transmit at 70CH by pressing
PTT key.
-. After transmission, when an acknowledgement from the target ship is
received, the audible beep sound is heard and “ACK” is displayed on the LCD.
-. When 2 seconds is passed after receipt of acknowledge, the unit will switch to
selected Channel number and “DSC” mode will be exited.
When DSC mode is exited,”DSC” and “ACK” will be eliminated.
Channel Display(Large) displays the selected Channel number.
Channel Display(Small) is eliminated.
-. If an acknowledge from the target ship is not received, “Individual Ship’s Call” at
70CH is still remaining in use.
(“Individual Ship’s Call” can transmit again by pressing PTT key)