Operation Manual

Chapter 4: Operating the Radio 21
4.13 Using the Scan Modes
The RAY101E is equipped with three types of scan options: All Scan, Saved
(Memory) Scan and Priority Scan. If there are no channels in memory, the
default is All Scan.
This function automatically searches for transmissions on the channel set
being scanned. If a TX signal is received, the scan stops on the receiving
channel as long as it is present and the SCAN indicator flashes. If the signal is
lost for five seconds, the radio resumes scanning.
During the Scan Modes:
• Press the Channel UP/DOWN key to change the scan direction.
UP increments the channel while DOWN decrements it.
• Press and release SCAN/SAVE to terminate the SCAN mode.
• DW/TRI and
*
keys do not function and sound an error beep if pressed.
Note: Scan modes are disabled when the ATIS operation is active.
All Scan
Press and release the SCAN/SAVE key when no channels are stored in
memory to activate the All Scan function.
The SCAN indicator appears on the LCD during All Scan.