Operation Manual

60 Ray218E and Ray55E Marine VHF Radios
Settings
You can also set how some time and position information is displayed on the
screen. Make your selection from the options on the list.
Latitude/Longitude Display
The LAT/LON DISP setting indicates whether Latitude and Longitude position data
are displayed on the screen in standby mode.
Time Display
The TIME DISPLAY setting indicates whether time information is displayed on the
screen in standby mode. When manual time is used, it is always displayed as UTC
time, even if you have entered an offset.
Note: If TIME DISPLAY is set ON, COG/SOG is automatically set to OFF. Because they oc-
cupy the same line on the LCD, only one of these two settings can be displayed at a time.
Time Offset
The TIME OFFSET setting indicates the amount of time to add or subtract from
UTC time to equal your local time. Rotate the
CH/OK knob to select a value from
between +13 to –13 hours of UTC and then press ACCEPT to confirm. After
setting up Time Offset, “LOC” is displayed to the right of the Time field to indicate
local time.
Note: The Time Offset setting is valid only when GPS data is available. When manual time
is used, it is always displayed as UTC time, even though you have entered an offset.
Time Format
The TIME FORMAT setting indicates whether the time is displayed in 12 hour or 24
hour format.
09
SHIP/SHIP
B
A
SELECT SELECT
I
N
T
GPS SETUP
MANUAL POS
SETTING
NMEA OUTPUT
[BACK]
09
SHIP/SHIP
B
A
I
N
T
SETTING
D9381-1
SELECT
09
SHIP/SHIP
B
A
I
N
T
SETTING
LAT/LON DISP
TIME DISPLAY
TIME OFFSET
TIME FORMAT
COG/SOG
LAT/LON DISP
TIME DISPLAY
TIME OFFSET
TIME FORMAT
COG/SOG