Specifications

Programming software installation 5
Programming software installation
Introduction
The CD-ROM in this kit contains the software required to operate the
programming dongle.
This section deals how to install the programming software onto your PC.
Installation
To install the programming software using the CD-ROM:
1. Insert the CD into the computer’s CD-ROM drive. After a few moments the
Install Shield Wizard Welcome screen is displayed.
2. Click
Next, and follow the on-screen instructions.
If the Install Shield Wizard does not automatically run;
1. Select Start/Run from the computer taskbar and type e:\setup.exe
(substitute the drive letter of your CD-ROM drive for ‘e’ if it is different). After
a few moments the Install Shield Wizard Welcome screen is displayed.
2. Click Next , and follow the on-screen instructions.