Operation Manual

70 Ray54E VHF Radio
Channel (CH) Name
By default, the Ray54E lists a descriptive name of up to 12 characters in the
top line of the dot matrix display for each channel. This option modifies the
name for the currently-selected channel from its default.
Display Name
Use this option to toggle the Channel Name ON or OFF. If off, the top line of
the dot matrix display is blank for that channel.
CH Info
Using this feature you can delete or change the Channel Names from the
default.
1. From the CH NAME menu item, rotate the CH knob until the arrow on the
dot matrix display points to CH INFO.
2. Push in the CH knob to select. The currently assigned name appears.
3. Push the CH knob to display your options:
EDIT changes the channel name displayed.
CLEAR completely removes the channel name. The top line of the dot
matrix display is blank for that channel.
4. Push CH again to select EDIT or CLEAR.
5. If you select EDIT, use the CH knob to modify the NAME field using the
same technique described in Adding an Entry on page 59.
Deleting a Channel Name Entry
Use this feature to completely remove a Channel Name from the list. If the
name is deleted, the top line of the dot matrix display is blank for that channel.
Note: The CH NAME is not returned to the factory default value following a
reset (page 84).
Ring Volume
This setting is used to set the volume of the ring that is sounded when an
incoming call is received. Select HIGH or LOW.
Note: The ring volume setting is overridden if a DSC Urgency or Distress
Call is received. These alarms must meet volume levels required by regula-
tions.
Key Beep
This setting is used to set the volume of the beep that sounds when a key is
pressed. Select HIGH, LOW or OFF.