RMK-9 Installation and Operation instructions ENGLIS H Da te : 04-2013 Docume nt numbe r: 81351-1-EN © 2013 Ra yma rine UK Limite d
ENGLISH Document number: 81351-1 Date: 04-2013
Handbook information This handbook contains important information regarding your product. using the dedicated alternate power connector. The keypad can be mounted horizontally or vertically with a keypad mat for both orientations supplied. A80217 This handbook includes information to help you: RMK–9 keypad (Using portrait keypad mat.
Water ingress • Raymarine specified cables are used. Water ingress disclaimer • Cables are not cut or extended, unless doing so is detailed in the installation manual. Although the waterproof rating capacity of this product meets the IPX6 standard, water intrusion and subsequent equipment failure may occur if the product is subjected to commercial high-pressure washing. Raymarine will not warrant products subjected to high-pressure washing.
6. Documentation pack. Flush mounting the keypad 7. Right angled power cable 2 m (6.6 ft.). For flush mounting you must rebate the mounting surface to accommodate keypad. Note: The appropriate tightening torque and drill bit size to use depends on the thickness of the mounting surface and the type of material it is made from. 8. RayNet network cable 2 m (6.6 ft.). Note: The supplied gasket provides a seal between the unit and a suitably flat and stiff mounting surface or binnacle.
8. Place the supplied gasket onto the rear of the keypad, ensuring the mounting holes are aligned. 9. Connect relevant cables. 3. Close the opposite end of the keypad mat into the keypad ensuring that the end tab and all side tabs (shown below) click firmly into place. 10. Secure using the fixings provided. 4. With all 3 tabs along one side of the keypad free the keypad mat should easily come away from the keypad.
Warning: Product grounding Before applying power to this product, ensure it has been correctly grounded, in accordance with the instructions in this guide. displays. If the network does not provide Power over Ethernet (PoE) then the keypad must be powered separately.
Network connection — Raymarine multifunction displays 1 Keypad controls Connecting the keypad allows you to control your multifunction display remotely.
2. Select Pair Keypad. 3. Press any button on the external keypad. 4. From the pop-up message select the orientation of the keypad. Either landscape or portrait orientations are available. The keypad is now paired. Switching the active pane or display using the keypad The Switch Active button is used to switch the active pane on a multi application page and / or to switch the active display.
RayNet to RJ45 SeaTalkhs adapter cables Wired connections Network / power 1 x RayNet connector Cable Part number • gS Series — 1000 Mb/s plus PoE. 1 m (3.28 ft) RayNet to RJ45 SeaTalkhs cable A62360 3 m (9.84 ft) RayNet to RJ45 SeaTalkhs cable A80151 10 m (32.8 ft) RayNet to RJ45 SeaTalkhs cable A80159 400 mm (1.3 ft) RayNet to RJ45 SeaTalkhs (female) cable A80160 • a, c, e Series — 100 Mb/s. Alternate power 1 x Power connector.
www.ra ym a rin e .
