User`s guide

18 Raymarine 37STV Satellite TV System
• Use the supplied PC program (This is the recommended
method). Load the appropriate folder for DirecTV with multi-
switch and DiSEqC supplier and follow the instructions in
“Loading default satellite information using the CD-ROM” on
page 39.
Europe
The following section shows the set up combinations for Europe.
Single IRD
This is the basic method for connecting your Raymarine 37STV
Satellite TV System.
The 3 m ACU set-top cable should be connected from the
RECEIVER port of the ACU to ‘LNB’, ‘ANT’ or ‘Satellite In’ on
the rear panel of the IRD.
Twin IRDs
You can connect two IRDs to your antenna as shown in the
diagram above. However, only one of the IRDs can be
configured as a two satellite receiver. The other IRD needs to be
configured as a one satellite receiver.
The two satellite receiver determines which satellite is tracked,
while the other receiver can watch any channel which is
available from the tracked satellite.
To connect twin IRDs:
1. Connect the system as for a single IRD as described in “Sin-
gle IRD” on page 14.
2. Remove the protective cover from the RF2 connector on the
antenna base plate.
3. Connect an RF cable to the RF2 connector on the antenna
RF1
RF2
D10504_1
IRD (not supplied)
RF1 RF2
IRD 1 (not supplied)
IRD 2 (not supplied)
D10579_1
81304_1.book Page 18 Tuesday, July 31, 2007 2:44 PM