Installation Manual Water Purification System PS-4 PS-8

If multiple remote display/keypads are installed: Never connect more than 2 wires to any terminal

block. Two remotes can be wired back to the Aqua Logic main unit or the second display/keypad (and

third, if applicable) can be “daisy chained” with one display/keypad wired to the next. The maximum wire

run from the Aqua Logic main unit to the furthest remote display/keypad is 500 ft (160m).

Base Receiver

Plug in the pigtail connector from the wireless base receiver into the “wireless” connector on the main PCB

in the Aqua Logic control unit.

Flow Switch

Only applicable if the chlorinator function is enabled. The flow switch cable plugs into the Aqua Logic

Control Center at the position shown in the diagram on page 10. Ensure that the connector catch “snaps”

in order to provide a reliable connection.

Turbo Cell

Only applicable if the chlorinator function is enabled. The Turbo Cell should be plugged in after the

Aqua Logic cover panel is put back in place. Refer to the diagram on page 10 for the location of the

connector.

Base Receiver

(AQL-BASE-RF)

Tighten nut

Aqua Logic

Main PCB

Connector for

Base Receiver