Installation Manual

NCR 6632
3
Considerations before installing C5
Before installing C5 to an ATM, visually inspect the ATM to detect any abnormalities that could negatively affect the
regular functionality of C5.
In case you face any of the problems listed below quit the installation.
List of conditions where C5 should not be installed:
 Evidence of vandalism (broken bezel, open or broken fascia, unscrewed side panels, broken screws, damaged
dispenser etc.)
 Problems in the opening space of the ATM
 If there is another operator working on the ATM.
 If the area doesn’t meet minimum security requirements (remote location, insufficient staff surveillance)
 If there is any problem caused by a natural phenomenon (flood, energy cut, air conditioning failure etc.)
What is C5
C5 is a control unit. It gives the possible to drive and monitor the locks and door switches connected to it. Thanks to C5,
the access to the ATM will be executed with OTCs (One time codes). Physical keys will not be longer needed.
The C5 is accompanied by a physical or digital keypad used to enter the One Time Codes. The electric or data driven
locks connected to the C5 will be triggered when a valid OTC is entered to keypad.
The MiniSmart Keypad and the locks can be set up and powered with OTCaccess controllers only.
The MiniSmart Keypad power sources shall be 12 Vdc SELV with LPS or PS2.